SHOWTEC Party Dimmer IEC User's Guide Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
5
Installation
Remove all packing materials from the Party Dimmer 4. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
You can control up to 4 Lights at a time.
1) When switch (3) is set to Dimmer Effect, you can increase the dimming effect from the light by moving
the slider of Channel 1-4.
2) When switch (3) is set to Sound Effect, the dimming effect from the light is controlled by the music via
the built-in microphone.
Note : Link cables before connecting electric power
Installing mounting-plates for 19” rack fitting
Screw the 2 mounting-plates to the Party Dimmer 4. Now you can mount your Party Dimmer in a 19” rack.
Maintenance
The Showtec Party Dimmer 4 requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in liquid.
Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections with a
damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
Troubleshooting
Showtec Party Dimmer 4
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1. If the device does not operate properly, unplug the device.
2. Check power from the wall, all cables, the fuse, etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If nothing happens after 30 seconds, unplug the device.
5. Return the device to your Showtec dealer.
Page view 6
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments