SHOWTEC Party Dimmer IEC User's Guide Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 21
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
13
Main Menu Options
Auto
DMX address
Slave
Built-in Programs
The Cameleon Spot will only show its version number at start-up !
1. Auto Run Program
1) Press and hold down the LEFT button on the device for 3 seconds at a time, until the display
shows .
2) With this menu you can set the Auto Mode of the Cameleon Bar.
3) Press the LEFT button to enter the AUTO Menu. You can choose 3 different sub menus.
Speed from 00-99 and FL
Flash Frequency from 00-99
Fade Time from 00-99
Use the LEFT button to scroll through the menu.
Use the RIGHT button to change the values.
2. DMX Mode
With this menu you can set the DMX address.
1) Press and hold down the LEFT button on the device for 3 seconds at a time, until the display.
shows .
2) You can choose 512 different DMX addresses.
Use the RIGHT button to select the required address from .
3) You can also press the LEFT button to set a different DMX Mode .
5 Channels
3 Channels
3. Slave Mode
With this menu you can set the device to slave mode.
1) Press and hold down the LEFT button on the device for 3 seconds at a time, until the display.
shows .
2) The device is a slave device. It will now react the same as its master.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments