SHOWTEC Scanmaster 2 MKII User's Guide download pdf (Page 14)

4) Press the TAP/Display button (19) to change between the 8 Channel or 16 Channel mode.

5) Press the FIXTURE button (1) to select the scanner.

6) While holding the MODE button (8), press the corresponding SCENE button (2) for the channel you wish

to reverse. (For Example: If you are reversing the one fixture, once you verify that you are in reverse

mode, and the Tilt LED is lit, check to see which slider the Tilt control is on. Hold the MODE button (8)

and press the SCENE button (2), that is same as the slider number for tilt. (Slider 5/Scene 5).

7) Continue steps 3-7 as needed. You may reverse a maximum of 48 channels for 12 scanners.

Delete a Scanner of DMX Channels

1) Activate Assign or reverse mode.

2) Tap the FIXTURE button (1) to select the scanner you wish to delete.

3) Press the MODE and AUTO/Del buttons (8+18) at the same time". All LEDs will flash three times,

indicating the requested operation has been performed.

Clear All DMX Channels

1) Turn the unit’s power off.

2) Press the MODE and AUTO/Del buttons (8+18) at the same time.

3) While holding the two buttons, turn the power back on. All LEDs will flash briefly, indicating the requested

operation has been performed.

Display DMX Channel

1) Press the FINE and MODE buttons (7+8) at the same time, putting the controller into assign mode.

2) Press the FINE and MODE buttons (7+8) again, lighting the reverse LED.

3) Press the FIXTURE button (1) that is set at the desired Pan and Tilt, and the LCD will display the DMX

values for Pan and Tilt.

Delete Pan / Tilt channel

1) When you are in "Assign" or "Reverse" operating mode, press the related FIXTURE button (1).

2) Press and hold down the MODE button (8), and then tap the AUTO/Del button (18) to delete the Pan/Tilt

channel.

Delete all Pan / Tilt channels

Turn the unit’s power off, press and hold down the AUTO/Del and MODE buttons (8+18) at the same

time. All LEDs will flash briefly, meaning all your Pan / Tilt channels have been deleted.

2) Re-apply the power, and all Pan / Tilt channels should be cleared.

FADE TIME

Fade Time / Assign Fade Time

1) Press and hold down the MODE button (8), and then tap the TaP/Disp button (19), the display may show

you "ONLY"; Repeat this operation when "only" appears, the display will show you "AH".

2) The "ONLY" or "ALL" display will go out automatically after 3 seconds.

"ALL" means that All channels run by the fade time.

"Only" means that only the preset PAN/TILT channels run by the fade time.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

No comments

SHOWTEC Scanmaster 2 MKII User's Guide Page 14