SHOWTEC Scanmaster 2 MKII User's Guide download pdf (Page 4)

WARNING

FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY

BEFORE YOUR INITIAL START-UP!

SAFETY INSTRUCTIONS

Every person involved with the installation, operation and maintenance of this device has to:

- be qualified

- follow the instructions of this manual

Before your initial start-up, please make sure that there is no damage caused by transportation. Should

there be any, consult your dealer and do not use the device.

To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to follow

the safety instructions and warning notes written in this manual.

Please consider that damages caused by manual modifications to the device are not subject to warranty.

This device contains no user-serviceable parts. Refer servicing to qualified technicians only.

IMPORTANT:

The manufacturer will not accept liability for any resulting damages caused by the non-observance of

this manual or any unauthorized modification to the device.

• Never let the power-cord come into contact with other cables! Handle the power-cord and all

connections with the mains with particular caution!

• Never remove warning or informative labels from the unit.

• Never leave any cables lying around.

• Do not insert objects into air vents.

• Do not open the device and do not modify the device.

• Do not connect this device to a dimmerpack.

• Do not shake the device. Avoid brute force when installing or operating the device.

• Do not switch the device on and off in short intervals, as this would reduce the system’s life.

• Only use device indoor, avoid contact with water or other liquids.

• Avoid flames and do not put close to flammable liquids or gases.

• Always disconnect power from the mains, when device is not used or before cleaning! Only handle

the power-cord by the plug. Never pull out the plug by tugging the power-cord.

• Make sure that the device is not exposed to extreme heat, moisture or dust.

• Make sure that the available voltage is not higher than stated on the rear panel.

• Make sure that the power-cord is never crimped or damaged. Check the device and the power-cord

from time to time.

• If device is dropped or struck, disconnect mains power supply immediately. Have a qualified

engineer inspect for safety before operating.

CAUTION!

Keep this device away from rain and moisture!

CAUTION! Be careful with your operations.

With a dangerous voltage you can suffer

a dan

erous electric shock when touchin

the wires!

1 2 3 4 5 6 7 8 9 ... 18 19

No comments

SHOWTEC Scanmaster 2 MKII User's Guide Page 4