7
SCENES
When powered on, this unit will first be in Manual control mode, and all channel outputs are in black-out
state (the Blackout LED flashes in the display window). You can also press the Blackout button to enable
the channel output.
Press and hold down the PROGRAM button (15) for 3 seconds till the PROG LED flashes, this means you
have entered the programming mode. Press and again hold down the PROGRAM button (15) for 3 seconds
(till the PROG LED goes out) to exit from the Programming mode.
Recording a scene
1) Enter program mode.
2) Check the BLACKOUT (20) and verify that the LED is not lit, if it is, press it once to exit blackout mode.
3) Verify that the SPEED and FADETIME sliders (5+6) are positioned at zero.
4) Press the FIXTURE button (1) corresponding to the unit wish to control. its LED will be lit.
You may control more than one scanner at time by pressing the button corresponding to the scanners)
you wish to program.
5) Move the faders and joystick to the desired position to set a scene. If necessary, you can use the
CHANNEL BANK button (4) to select between Ch1-8 and Ch9-16 as your desire.
6) Tap the BANK Up/Down button (11) to choose the bank you want to store this scene into. There are a
total of 30 banks you can select, you may store up to 8 scenes in each bank.
7) Once all fixtures are programmed into the desired position for the scene, tap the MIDI/Rec button (17) to
program this scene into memory.
8) select the SCENE button (2) you wish to store your scene into. All LEDs flash briefly, this means your
setting has been saved.. The LCD readout will show the bank and scene.
9) To unselect the scanner(s) you have been programming and switch to another, simply press the button of
the scanner you have been programming again, deselecting it, and select another scanner.
10) Repeat steps 2-7 until all scenes have been programmed.
11) If you don't intend to continue programming at this time, press and hold the PROGRAM button (15) for
three seconds to exit program mode. The LED will go out indicating this selection.
Note: The recorded scene can be re-edited; if you re-edit a scene and save it, the old scene will be
replaced by the new one.
Example Scene Program
1) Program Enable
2) Tap the FIXTURE 1 button (1) to turn on its fader control.
3) Verify that the page select is set on Ch1-8, if not press the CHANNEL BANK button (4) to select Ch1-8.
4) Move the first and second faders all the way up-to their maximum value position.
5) Select BANK 1 using the BANK Up/Down buttons (11).
6) Press the MIDI/Rec button (17).
7) Tap SCENE 1 button (2) to store the first scene.
8) Repeat steps 4-7, until all scenes have been programmed into BANK 1.
9) Tap the FIXTURE 1 button (1) to turn off the fader control.
10) When finished, disable PROGRAM mode. You can now manually tap through you have just
programmed.
(13 pages)
(19 pages)
(35 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals