SHOWTEC Black Widow User's Guide Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
6
8) DOWN button
Press to decrease the display value
9) UP button
Press to increase the display value.
10) FULL ON button
Press this button to bring overall channels to full intensity.
Release will deactivate this mode.
11) STAND BY button
Tap this button to kill all output except that the FULL ON button is pressed.
A second tap of this button will leave this mode.
12) Mode Select switch
Move the switch to the left, it may control the Q-strobe 2;
Move the switch to the right, it may control the Titan-Strobe.
13) Audio Input
This jack accepts a line level audio input signal to synchronize chase and provide audio intensity effects.
The audio input signal ranges from 100mV to 1Vpp.
14) DMX Polarity Select switch
Move the switch to the left, the DMX output is a 3-pin XLR female with pin 2(data-).
Move to the right, the DMX output is a 3-pin XLR female with pin 2(data+).
15) DMX OUT
Connect the DMX output to the DMX input on the first strobe with DMX protocol.
16) Channel Output
Connect these output to the input on the analogue strobe.
17) Power Supply
This input jack uses a recommended AC-DC adapter.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Damages caused by non-observance are not subject to warranty.
Operation Modes
1) Audio Mode
Press the AUDIO button causing the Segment Display shows, the programs chase with audio intensity
effects.
2) Program Mode
Press the PROGRAM button, the program will chase at the current speed, dimming level and audio
intensity. Tap the UP/DOWN button to select the program from 20 built-in programs to chase.
3) Speed Mode
Press the SPEED button, then adjust the speed using UP/DOWN button.
4) Dimmer Mode
Press the DIMMER button, then adjust the dimming level using UP/DOWN button.
5) Full On Mode
Press the FULL ON button to bring overall output to full intensity. Release will deactivate this mode.
6) Stand By Mode
Tap the STAND BY button to kill all output except that Full On is activated, and the LED blinks indicating
Stand By is active. A second tap will leave this mode.
Page view 7
1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments