SHOWTEC Black Widow User's Guide Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 11
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
7
Maintenance
The Showtec StrobeCon-4 requires almost no maintenance. However, you should keep the unit clean.
Otherwise, the fixture’s light-output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe glass clean with glass cleaner and a
soft cloth. Do not use alcohol or solvents.
The glass will require regular cleaning, as smoke-fluid tends to build up residues, reducing the light-output
quickly.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections with a
damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.
The following points have to be considered during the inspection:
1. All screws used for installing the device or parts of the device have to be tightly connected and must
not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. The electric power supply cables must not show any damages or material fatigue.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the light effect does not operate properly, refer servicing to a technician.
Check that the unit is plugged into an appropriate power supply.
No Response
Response: Suspect the Jack cable or connectors, a controller malfunction, a light effect DMX card
malfunction.
1. Check the Power cable: Unplug the unit; change the Power cable; then reconnect to electrical power. Try
your control again.
2. Determine whether the controller or light effect is at fault. Does the controller operate properly with other
products ? If not, take the controller in for repair. If so, take the Jack cable and the light effect to a
qualified technician.
Page view 8
1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments