3
• Always disconnect power from the mains, when device is not used, before cleaning or when
replacing lamp! Only handle the power-cord by the plug. Never pull out the plug by tugging the
power-cord.
• Make sure that the device is not exposed to extreme heat, moisture or dust.
• Make sure that the available voltage is not higher than stated on the rear panel.
• Make sure that the power-cord is never crimped or damaged. Check the device and the power-cord
from time to time.
• Make sure that no side forces can impact on the truss system.
• Make sure that the cable diameter of the extension cords and powercables are sufficient for the
current consumption of the device.
• The powercable may not be modified, broken, mechanically strained, pressed together or heated.
• The cable insert or the female part in the device must never be strained. There must always be
sufficient cable to the device. Otherwise, the cable may be damaged which may lead to deadly
electrical shocks.
• If the external cable is damaged, it has to be replaced by a qualified technician.
• Never switch the lamp on if the housing cover is open. Burning lamps can cause a high ultraviolet
radiation, which can cause fire.
• Never let the strobe run without the protective shield!
• The protective shield has to be replaced when it is obviously damaged, so that its function is
impaired, e.g. due to cracks or deep scratches!
• If device is dropped or struck, disconnect mains power supply immediately. Have a qualified
engineer inspect for safety before operating.
• If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not
switch it on immediately. The arising condensation water might damage your device. Leave the
device switched off until it has reached room temperature.
• If your Showtec device fails to work properly, discontinue use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your Showtec dealer for service.
• For adult use only. Lighteffect must be installed out of the reach of children. Never leave the unit
running unattended.
• Allow time to cool down, before replacing lamp.
• Only install the device with the hanging-bracket.
• The user is responsible for correct positioning and operating of the Mini Strobe. The manufacturer
will not accept liability for damages caused by the misuse or incorrect installation of this device.
• This device falls under protection class II. Therefore it is essential to connect the yellow/green
conductor to earth.
• During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
• Repairs, servicing and electric connection must be carried out by a qualified technician.
• For replacement use lamps and fuses of same type and rating only.
• WARRANTY: Till one year after date of purchase.
OPERATING DETERMINATIONS
This device is not designed for permanent operation. Consistent operation breaks will ensure that the device
will serve you for a long time without defects.
The minimum distance between light-output and the illuminated surface must be more than 0,3 meters.
The maximum ambient temperature t
a
= 45°C must never be exceeded.
CAUTION ! EYEDAMAGES !.
Avoid looking directly into the light source.
meant es
eciall
for e
ile
tics
!
(5 pages)
(15 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals