SHOWTEC LED Wash Ultra Bright RGB User's Guide Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 15
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
7
Multiple LED Wash Ultra (DMX Control)
1. Fasten the effect light onto firm trussing (Use a 30-kg rated or stronger C-clamp bolted onto the
Showtec LED Wash bracket). Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the LED Wash’s and other devices.
3. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Set DMX dip switches as follows (See Dip Switch setting page 8).
LED Wash Ultra Address Value DMX Dip Switches "ON"
Unit 1 1
Unit 2 5
Unit 3 9
Unit 4 13
5. Supply electric power: Plug the end of the mains power cord into proper electric power supply sockets.
Do so for all units and the controller.
Multiple LED Wash Ultra Set Up
DMX-Set up
Master/Slave Set up
Fig. 4
Note : Link all DMX cables and set dip switches before connecting electric power
6. Do not supply power before the whole system is set up and connected properly.
Design your show according to your DMX controller functions. After every new dipswitch setting you
have to disconnect the power, and then turn the power on to activate the new dipswitch setting.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments