SHOWTEC LED Wash Ultra Bright RGB User's Guide download pdf (Page 15)

Connection Cables

Take care of the connector cables, always holding them by the connectors and avoiding knots and

twists when coiling them: This gives the advantage of increasing their life and reliability, which is always to

your advantage. Periodically check that your cables are in good condition, that they are correctly wired

and that all their contacts are perfectly efficient: a great number of problems are caused entirely by

using unsuitable or faulty cables.

Maintenance

The operator has to make sure that safety-relating and machine-technical installations are to be

inspected by an expert after every four years in the course of an acceptance test.

The operator has to make sure that safety-relating and machine-technical installations are to be

inspected by a skilled person once a year.

The following points have to be considered during the inspection:

1. All screws used for installing the device or parts of the device have to be tightly connected and must

not be corroded.

2. There may not be any deformations on housings, fixations and installation spots.

3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.

4. The electric power supply cables must not show any damages or material fatigue.

The LED Wash Ultra Bright Compact RGB requires almost no maintenance. However, you should keep the

unit clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not

immerse in liquid.

Keep connections clean. Disconnect electric power, and then wipe the audio connections with a damp

cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the

fuse burns out, the product will not function whatsoever. If this happens, follow the directions below to do

so.

1. Unplug the unit from electric power source.

2. Insert a screwdriver into the slot in the fuse cover. Gently pry up the fuse cover. The fuse will come out.

3. Remove the broken fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover.

Be sure to use a fuse of the same type and specification. See the product specification label for

details.

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

SHOWTEC LED Wash Ultra Bright RGB User's Guide Page 15