SHOWTEC LED Wash Ultra Bright RGB User's Guide download pdf (Page 9)

Backside

Fig. 2

1) Earth

2) Power Cable

3) Fuse 0,5A

4) 3-pin DMX signal connector (IN)

5) 3-pin DMX signal connector (OUT)

6) Dip Switches

Installation

Remove all packing materials from the LED Wash Ultra Bright RGB. Check that all foam and plastic

padding is removed. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Note : Link all cables before connecting electric power.

Control Modes

There are 4 modes: • Stand-alone (built-in programs)

• Sound-controlled

• Master/Slave (only by dipswitches, no DMX)

• DMX512 (5 Channels)

One LED Wash Ultra Bright RGB (Built-in Auto Program)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. Plug the cord into a proper electric power supply socket.

3. When the LED Wash Ultra is not connected by a DMX-cable, it functions as a stand-alone device.

All dipswitches must be set to OFF for Automatic control.

In Built-in Program Mode the device changes color and fades from color to color.

All Dipswitches must be OFF

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

SHOWTEC LED Wash Ultra Bright RGB User's Guide Page 9