SHOWTEC Light Desk Pro 136 User's Guide download pdf (Page 13)

Step Mix/sequence

The MIX/SEQUENCE button (6) has the following options:

1) MIX MODE

In “mix”-mode the LED of the active “chase” blinks and the LED above the MIX/SEQUENCE button (6)

is flashing RED. When CHASE 1 and CHASE 2 are selected, CHASE 1 will run first and then CHASE 2.

2) SEQUENCE MODE

In “sequence”-mode the LEDs of the selected “chases” blink synchronously and the LED above the

MIX/SEQUENCE button (6) is RED. In “sequence”-mode only the program, which has been selected last,

runs.

Note: Switching between “mix”-mode or “sequence”-mode is only possible when all “chases” have been de-

selected!

Step

When a “chase” is running, all steps can be manually walked through by pressing the STEP button (6).

Audio

When AUDIO (9) is activated, the “chase” will respond to the music via the internal mic.

Group

During programming the “fixture” button, which was pushed last, is selected. You can select two or more

“fixtures” by using the GROUP function (7). With this function multiple “fixtures” can be selected, for

example: you can change the color of 4 movingheads at the same time.

Hold down the GROUP button (7) and at the same time press “fixture” buttons, you want to use together.

The LEDs above these buttons will flash synchronously, this means that these “fixtures” now belong to a

group.

Note: The GROUP button (7) only works in program mode.

Black Out

When pushing the BLACK OUT button (10) all DMX activities from the moving light are de-activated. The

programs keep on running, but no signal is sent to the “fixtures”.

Conventional Light

Conventional light (parcans, etc) does not need to be patched, because this light only has 1 DMX channel.

The DMX channels for conventinal light start at address 129, because all prior addresses are reserved for

moving lighteffects.

To keep programming and controlling simple, this Light Desk Pro 136 has been devided in 2 parts. The left

side is for moving light effects and the right side is for conventional light.

Programming

Hold down the RECORD button (15) for 5 seconds, the green LED will illuminate.

SELECT A SCENE OR CHASE! PAGE01

First press the PAGE button (32). Now you can change the PAGE number (32) with the UP/DOWN buttons

(17 &18).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

SHOWTEC Light Desk Pro 136 User's Guide Page 13