SHOWTEC Light Desk Pro 136 User's Guide download pdf (Page 19)

Removing the rubber housing for 19” rack fitting

Remove the 4 screws (A, B, C, D) on the side and the 4 screws (E, F, G, H) on the top and bottom. Now you

can mount your Light Desk Pro 136 in a 19” rack.

Maintenance

The Showtec Light Desk Pro 136 requires almost no maintenance. However, you should keep the unit

clean. Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in

liquid. Do not use alcohol or solvents.

Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections with a

damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric power.

Troubleshooting

Showtec Light Desk Pro 136

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps.

1. If the device does not operate properly, unplug the device.

2. Check power from the wall, all cables, the fuse, etc.

3. If all of the above appears to be O.K., plug the unit in again.

4. If nothing happens after 30 seconds, unplug the device.

5. Return the device to your Showtec dealer.

1 2 ... 14 15 16 17 18 19 20 21

No comments

SHOWTEC Light Desk Pro 136 User's Guide Page 19