3) If you connect 8 units, make sure, the address off the fourth slave (the fifth unit) is set to1, the
next at Address 2 etc.
Set the address DIP switch of the first slave at 2.
Address = 2
Set the address DIP switch of the second slave at 3.
Address = 3
Set the address DIP switch of the third slave at 4.
Address = 4
Set the address DIP switch of the fourth slave at 1.
Address = 1
Set the address DIP switch of the fifth slave at 2.
Address = 2
Set the address DIP switch of the sixth slave at 3.
Address = 3
Set the address DIP switch of the seventh slave at 4.
Address = 4
8. Plug in the powercable
Comments to this Manuals