SHOWTEC MiniMax 250 User's Guide download pdf (Page 18)

Troubleshooting

No Light, No Movement

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps.

If the light effect does not operate properly, refer servicing to a technician.

Response: Suspect three potential problem areas: the power supply or the lamp.

1. Power supply. Check that the unit is plugged into an appropriate power supply.

2. The lamp. Replace the old lamp with a new one with the same specifications. See page 7 for replacing

lamps.

3. The fuse. Replace the fuse. See page 15 for replacing the fuse.

No Response to DMX

Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card

malfunction.

1. Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power. Try

your DMX control again.

2. Determine whether the controller or light effect is at fault. Does the controller operate properly with other

DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light effect to a

qualified technician.

See next page for more problem solving.

1 2 ... 13 14 15 16 17 18 19 20 21

No comments

SHOWTEC MiniMax 250 User's Guide Page 18