SHOWTEC Galactic GVC-190 User's Guide download pdf (Page 11)

Control Modes

There are 4 modes: • Auto run (visual effects)

• Sound-controlled

• Master/Slave

• DMX512

One Galactic (Auto run visual effects)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the Galactic is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 13 for more information about the Auto run visual effects.

One Galactic (Sound-control)

1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.

2. Turn on the music. If the device is set to sound, then the Galactic will react to the beat of the music.

Please see page 13 for more information about the sound-control options.

Multiple Galactics (Master/Slave control)

1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.

2. Always use a safety cable (ordercode 70140 / 70141).

3. Use a 3-p XLR cable to connect the Galactic lasers.

The pins:

1. Earth

2. Signal -

3. Signal +

4. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

You can use the same functions on the master device as described on page 13 (Autorun or Music

control). This means on the master device you can set your desired operation Mode and all slave

devices will react the same as the master device.

Multiple Galactics (Master/Slave control)

Fig. 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

No comments

SHOWTEC Galactic GVC-190 User's Guide Page 11