SHOWTEC LED Par 64 Short DMX User's Guide Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
10
The LED Par 64 can be operated with a controller in control mode or without the controller in stand-alone
mode.
Control Panel
Fig. 5
A. LCD Display D. Up Button
B. MODE button E. Down Button
C. SETUP Button
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the
controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the LED Par 64 allows you to assign the DMX fixture address, which is
the first channel from which the LED Par 64 will respond to the controller.
Please note when you use the controller, the unit has 8 channels.
When using multiple LED Pars, make sure you set the DMX addresses right.
Therefore, the DMX address of the first LED Par 64 should be 1(A001); the DMX address of the second LED
Par 64 should be 1+8=9 (d009); the DMX address of the third LED Par 64 should be 9+8=17 (d017), etc.
Please, be sure that you don’t have any overlapping channels in order to control each LED Par 64
correctly.
If two or more LED Pars are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under ”Addressing’.
Controlling:
After having addressed all LED Par 64 fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the LED Par 64 will automatically detect whether DMX 512 data is received or
not. If there is no data received at the DMX-input, the “LED “ on the control panel will not flash.
The problem may be:
- The XLR cable from the controller is not connected with the input of the LED Par 64.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Comments to this Manuals

No comments