SHOWTEC LED Par 64 Short DMX User's Guide download pdf (Page 9)

Installation

Remove all packing materials from the LED Par 64. Check that all foam and plastic padding is removed.

Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Control Modes

There are 5 modes: • Built-in Programs

• Auto Run

• Sound-controlled

• DMX512 Auto Program

• Master/Slave

One LED Par 64 (Built-in Programs, Auto Run)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the LED Par 64 is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 12 or 13 for more information about the built-in programs.

One LED Par 64 (Sound-control)

1.Plug the end of the electric mains power cord into a proper electric power supply socket.

2. Turn on the music. If device is set to (Audio) and you have pressed enter,

then the fixture will react to the beat of the music. Please see page 12 for more information about the

sound-control options.

Multiple LED Pars (Master/Slave control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. Use a 3-p XLR cable to connect the LED Par 64.

The pins: 1. Earth

2. Signal -

3. Signal +

3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"

socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

You can use the same functions on the master device as described on page 12+13 (Built-in Programs,

Auto Run or Music control). This means on the master device you can set your desired

operation Mode and all slave devices will react the same as the master device.

Multiple LED Pars (Master/Slave control)

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

No comments

SHOWTEC LED Par 64 Short DMX User's Guide Page 9