SHOWTEC Phantom 575 Pro EB User's Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
8
Installation
Installing the Lamp
The Showtec Club Spot 575 uses the HMI 575 (ordercode 80901O) reflectorbulb as manufactured by all
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1. Loosen the 4 screws on the back of the plastic housing.
2. Gently remove the small metal housing. Loosen the 4 screws of the lamp cover.
3. Read lamp instructions. Do not touch the lamp bulb glass. (See Figure 3.)
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.).
4. Insert the lamp pins into the small holes in the lamp socket.
5. Put the lamp cover back and fasten the screws snugly. Then put the metal housing back and fasten the
screws snugly
1 2 3
Fig. 3
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Comments to this Manuals

No comments