SHOWTEC Nebula S-150 User's Guide download pdf (Page 11)

Multiple Nebula’s (DMX Control) Dipswitch #9 must be OFF

1. Fasten the effect light onto firm trussing Leave at least 0,5 meter on all sides for air circulation.

2. Always use a safety cable.

3. Use a 3-p XLR cable to connect the Nebula’s and other devices.

4. Link the units as shown in (figure 5), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

5. Set DMX dip switches as follows (See Dip Switch setting page 11).

Nebula Address Value Dip Switches "ON"

Unit 1 1 #1

Unit 2 2 #2

Unit 3 3 #1 and #2

Unit 4 4 #3

6. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the

other end of the mains power cord into proper electric power supply sockets, starting with the first unit.

Do not supply power before the whole system is set up and connected properly.

Multiple Nebula’s DMX Set Up

Fig. 5

Note : Link all cables and set dip switches before connecting electric power

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

SHOWTEC Nebula S-150 User's Guide Page 11