The “Intensity channel”, otherwise known as the “dimmer” channel is on channel 16 and its values
go from 0 to 255. Enter them as shown above.
Some fixtures have the dimmer channel shared with the strobe channel or some other feature, you
would still put the range of the dimmer in these input boxes as it is defined in the manual.
This fixture uses the same channel for the shutter and strobing, which is quite common to a lot of
fixtures as it is the mechanical shutter that opens and closes causes the strobing effect.
Anyway enter the “Shutter ch.” values and “Strobe ch.” values as shown above and below.
Did you notice that you could not enter a value in the “off” value for the “Strobe ch.” That is
because the Fixture Creator knows that the strobe channel is shared with the shutter channel.
Comments to this Manuals