SHOWTEC Infinity iS-200 User Manual download pdf (Page 30)

Ordercode: 41501

Infinity iS-200

Fig. 08

03) Loosen the service lid of the housing, by sliding it to the bottom.

04) Gently tilt the head so the small metal housing will slide out more easy.

05) Turn the gobo wheel, with the gobo you want to remove, to the upside.

06) Gently lift up the gobo holder 10º and then gently pull out the gobo from its position.

Fig. 09

07) Very carefully take the gobo out of the gobo holder with a pair of pliers.

08) Place the new gobo in the gobo holder. Carefully put the pinchcock back, gently press the

pinchcock a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.

09) Put the gobo holder back under the pressing snap and push it back.

10) Replace the maintenance caps and fasten all screws.

Glass Gobo Orientation

Coated glass gobos are inserted with the coating against the rim of the holder (away from the spring).

Textured gobos are inserted with the smooth side against the spring. This provides the best results when

combining rotating gobos.

Coated side

Uncoated side

When an object is held up to the coated side

there is no space between the object and its

reflection. The back edge of the gobo cannot be

seen when looking through the coated side.

When an object is held up to the uncoated side

there is a space between the object and its

reflection. The back edge of the gobo can be

seen when looking through the uncoated side.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

No comments

SHOWTEC Infinity iS-200 User Manual Page 30