SHOWTEC Mini Apollo User's Guide download pdf (Page 7)

Description of the device

Features

The Showtec Mini Apollo is a light effect with high output and great effects.

• many colourful rotating lightbeams

• stand-alone

• Lamp JD E11 240V/100W (Ordercode 82290) Lamp included

Overview

Fig. 1

Installation

Installing the Lamp

The Mini Apollo uses the JD E11 240V/100W (Ordercode 82290) bulb, as manufactured by all popular

manufacturers. Use only the appropriate lamp for your unit. Note that, product versions that use other lamps,

may be offered in the future. Check your product specification label for information.

Always disconnect from electric mains power supply before changing lamps.

The lamp has to be replaced when it is damaged or deformed due to the heat.

Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device

was not designed for.

Damages caused by non-observance are not subject to warranty.

Warning: Allow 15 minutes to cool down, before replacing lamp.

Procedure :

1. Loosen the 3 screws of the lamp cover.

2. Gently remove the metal housing and take out the lamp. Read lamp instructions. Do not touch the lamp

bulb glass. (See Figure 2.). Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the

glass with a clean, lint-free towel and rubbing alcohol.).

3. Insert the lamp pins into the small holes in the lamp socket.

4. Put the housing back and fasten the screws snugly.

Fig. 2

1 2 3 4 5 6 7 8 9 10

No comments

SHOWTEC Mini Apollo User's Guide Page 7