SHOWTEC ORDERCODE 30645 User's Guide download pdf (Page 10)

Maintenance

The Showtec Multidim requires almost no maintenance. However, you should keep the unit clean.

Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in

liquid. Keep connections clean. Disconnect electric power, and then wipe the audio connections with a

damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying electric

power.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the

fuse burns out, the product will not function whatsoever. If this happens, follow the directions below to do

so.

1. Unplug the unit from electric power source.

2. Insert a screwdriver into the slot in the fuse cover. Turn the screwdriver to the left, at the same time

Gently push a bit (Turn and Push). The fuse will come out.

3. Remove the used fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to

use a fuse of the same type and specification. See the product specification label for details.

Troubleshooting

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps. If the Multidim does not operate properly, refer servicing to a technician. If the fuse is burned out,

replace the broken fuse with a new one, with the same specifications.

Response: Suspect two potential problem areas: the power supply or the fuse.

1. Power supply. Check that the unit is plugged into an appropriate power supply.

2. The fuse. Check if the fuses are ok.

1 2 ... 5 6 7 8 9 10 11 12

No comments

SHOWTEC ORDERCODE 30645 User's Guide Page 10