SHOWTEC Phantom 250 Spot User's Guide download pdf (Page 18)

Changing the Lamp

1. Disconnect mains power supply. Loosen the 2 screws on the back of the housing.

2. Gently remove the small metal housing.

3. Follow directions for installing a new lamp, page 7.

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the

fuse burns out, the product will not function whatsoever. If this happens, follow the directions below to do

so.

1. Unplug the unit from electric power source.

2. Insert a flat-head screwdriver into a slot in the fuse cover. Gently pry up the fuse cover. The fuse will

come out.

3. Remove the used fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to

use a fuse of the same type and specification. See the product specification label for details.

Replacing a Gobo

Gobo-wheel with rotating gobo’s

1. Disconnect mains power supply and set the switch to OFF.

2. Make sure that the gobo you want to insert has the same size.

3. Turn the gobo wheel, with the gobo you want to remove, to the upside.

4. Very carefully take the pinchcock (fig 7 and 8) out of the gobo wheel, but pay attention that the

pinchcock does not fall in the device. Then push the gobo out.

5. Place the new gobo in the gobo wheel. Carefully put the pinchcock back, gently press the pinchcock

a little bit together. Possibly use a pair of pliers to press the pinchcock a little bit together.

6. Replace the maintenance cap and fasten all screws.

pinchcock

gobo

Gobo Pan

Fig. 7 Fig. 8

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

SHOWTEC Phantom 250 Spot User's Guide Page 18