SHOWTEC Zipp LED DMX User's Guide download pdf (Page 12)

Multiple Pulsator LEDs (DMX Control)

1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.

2. Always use a safety cable (ordercode 70140 / 70141).

3. Use a 3-p XLR cable to connect the Pulsator LEDs and other devices.

4. Link the units as shown in (figure 5), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

5. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the

other end of the mains power cord into proper electric power supply sockets, starting with the first unit.

Do not supply power before the whole system is set up and connected properly.

Multiple Pulsator LEDs DMX Set Up

Fig. 5

Note : Link all cables and set dip switches before connecting electric power

After switching on, the Pulsator LED will automatically detect whether DMX 512 data is received or not. If

there is no data received, the problem may be:

- The XLR cable from the controller is not connected with the input of the Pulsator LED.

- The controller is switched off or defective, the cable or connector is detective, or the signal wires are

swapped in the input connector.

Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure

proper transmission on the DMX data link.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

SHOWTEC Zipp LED DMX User's Guide Page 12