SHOWTEC DJ Switch 8 User's Guide download pdf (Page 9)

Backside

Fig. 3

6) Dip Switches 10) Power ON/OFF

7) Remote Interlock Connector 11) DMX signal connector (OUT)

8) Sound Sensitivity control 12) IEC Power Connector / Fuse 2A / 250V

9) Key System 13) DMX signal connector (IN)

Remote Interlock Connector: Use a DB9 connector to connect to the Remote Interlock, which stops the

beam being emitted once the connection loop has been opened.

Key System: When the key is locked, the unit stops emitting the laserbeam but keeps the power on, and

the steppers keep working. Only when the key is turned, after 15 seconds, the projector

starts emitting the laserbeam. 5 seconds before emitting, there is a rattling sound.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Remove the protection cover from the front of the laser. When the laser is not in use, please replace the

cover to protect the laser.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

The laser will only work between 15-35ºC.

After 3 hours working, you must shut off the laser and let the laser diode cool off for 30 minutes,

otherwise the laser could be damaged and the warranty becomes void.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

SHOWTEC DJ Switch 8 User's Guide Page 9