SHOWTEC Zipp LED DMX User's Guide download pdf (Page 11)

Selecting DMX Address Mode

DMX mode is indicated by an “A” followed by 3 digits (001-512) in the LED Display.

Setting the DMX Address

Once you have activated the DMX Mode, you can push the UP or DOWN button

to change the setting from 001-512.

CHASE Mode

You can only use this mode when you are using the device as a Chaser. The unit has 16 built-in programs

except for Auto and Full. You can select any of these programs to create a chase for a lightshow.

You can also control the speed at which the programs will be chasing.

Selecting the Chase Mode

Chase mode is indicated by a “P” followed by 2 digits (01-16) in the LED Display.

“P” means Chase Mode and shows the Chase Mode has been activated.

If the Chase Mode has been activated, the Chase program Mode starts and

is the Default setting.

Setting the Chase Program

Once you have activated the Chase Mode, you can push the UP or DOWN button

to change the setting from 01-16. The Chase pattern is shown by a “P”

in the display and further by 01-16, AUTO or FULL.

You can select any of these settings to run at a single time.

Selecting the Chase Speed

To adjust the Chase Speed, you must activate the Chase Speed Mode.

Press the MENU Button until the display shows “SP” followed by 2 digits.

Setting the Chase Speed

In this Mode, you can adjust the Program Chase Speed. Use the UP or DOWN

button to change the setting from 01-99. A value of 01 means the slowest chase

speed of approximately once every 30 sec. A value of 99 means the fastest chase

speed of approximately 0.1 sec.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

SHOWTEC Zipp LED DMX User's Guide Page 11