SHOWTEC 42199 User's Guide download pdf (Page 12)

Control Panel

When the indicator light is on, means the LED Bar is working.

Fig. 5

A. LED Display D. Up Button

B. MODE Button E. Down Button

C. SETUP Button

DMX Control Mode

The fixtures are individually addressed on a data-link and connected to the controller.

The fixtures respond to the DMX signal from the controller.

DMX Addressing

The control panel on the front side of the base allows you to assign the DMX fixture address, which is the

first channel from which the LED Bar will respond to the controller.

Please note when you use the controller, the unit has max. 26 channels.

When using multiple LED Bars, make sure you set the DMX addresses right.

Therefore, the DMX address of the first LED Bar should be 1(A001); the DMX address of the second LED Bar

should be 1+26=27 (A027); the DMX address of the third LED Bar should be 27+26=53 (A053), etc.

Please, be sure that you don’t have any overlapping channels in order to control each LED Bar correctly.

If two or more LED Bars are addressed similarly, they will work similarly.

For address settings, please refer to the instructions under ”Addressing’ (menu d001)

Controlling:

After having addressed all LED Bars, you may now start operating these via your lighting controller.

Note: After switching on, the LED Bar will automatically detect whether DMX 512 data is received or not.

If there is no data received at the DMX-input, the “LED “ on the control panel will not flash.

The problem may be:

• The XLR cable from the controller is not connected with the input of the LED Light Bar.

• The controller is switched off or defective, the cable or connector is detective, or the signal wires are

swapped in the input connector.

Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure

proper transmission on the DMX data link.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

SHOWTEC 42199 User's Guide Page 12