SHOWTEC ORDERCODE 30645 User's Guide download pdf (Page 12)

Replacing a Fuse

Power surges, short-circuit or inappropriate electrical power supply may cause a fuse to burn out. If the fuse

burns out, the product will not function whatsoever. If this happens, follow the directions below to do so.

1. Unplug the unit from electric power source.

2. Insert a flat-head screwdriver into a slot in the fuse cover. Gently pry up the fuse cover. The fuse will

come out.

3. Remove the used fuse. If brown or unclear, it is burned out.

4. Insert the replacement fuse into the holder where the old fuse was. Reinsert the fuse cover. Be sure to

use a fuse of the same type and specification. See the product specification label for details.

Troubleshooting

This troubleshooting guide is meant to help solve simple problems.

If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit operates

properly, do not carry out following steps.

1. If the device does not operate properly, unplug the device.

2. Check the fuse, power from the wall, all cables etc.

3. If all of the above appears to be O.K., plug the unit in again.

4. If you are unable to determine the cause of the problem, do not open the device, as this may damage the

unit and the warranty will become void.

5. Return the device to your Showtec dealer.

No Light

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps.

If the light effect does not operate properly, refer servicing to a technician.

Response: Suspect three potential problem areas: the power supply, the lamp, the fuse.

1. Power supply. Check that the unit is plugged into an appropriate power supply.

2. The lamp. Replace the old lamp with a new one with the same specifications. See page 10 for replacing

the lamp.

3. The fuse. Replace the fuse. See page 10 for replacing the fuse.

No Response to DMX

Response: Suspect the DMX cable or connectors, a controller malfunction.

1. Check the DMX setting. Make sure that DMX addresses are correct.

2. Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power. Try

your DMX control again.

3. Determine whether the controller or light effect is at fault. Does the controller operate properly with other

DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light effect to a

qualified technician.

1 2 ... 7 8 9 10 11 12 13 14

No comments

SHOWTEC ORDERCODE 30645 User's Guide Page 12