SHOWTEC Studiobeam MSR-575 User's Guide download pdf (Page 10)

Installing a Lens

1. When installing the lens, make sure the fixture is on a safe height. Please prevent people from walking

under the fixture, when replacing the lens !

2. Position the fixture with the frontside of the unit (Lens Side) facing you. Then tilt its head slightly (Fig. 5).

3. Position the lens rotation ring with the spring clip at the top of the fixture, below the retaining clip.

4. Hold the lens by its edge and position it so, that the convex side faces the back of the fixture (Fig. 6).

Note: Installing the lens with the convex side out, will not only impair the optics, but it will also make

removing the lens difficult.

5. From the top of the fixture, slide the lens behind the lens catchers and position its base behind the tabs

on the bottom of the lens rotation ring.

6. Gently push the top of the lens inwards, until it snaps behind the spring clip.

Fig. 5 Fig. 6

Removing a Lens

1. Studiobeam lenses get hot while the unit is in operation. Let thefixture cool down before handling the

lens.

2. Place the fixture on a flat, stable worksurface.

Pay Attention Never install or remove lenses when the unit is hanging.

3. Position the lens rotation ring with the spring clip at the front of the unit, directly below the retaining clip.

4. Tilt the front of the fixture down at least 45º.

5. Press the spring clip with your fingers to release the lens (Fig. 5).

6. Allow the lens to gently drop forward from under the clip.

7. When the lens drops, remove your finger, allowing the lens to slide forward until it rests on the lens

catchers (Fig. 7).

8. Carefully remove the lens from the fixture.

Fig. 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

No comments

SHOWTEC Studiobeam MSR-575 User's Guide Page 10