SHOWTEC ImageSpot 300 User's Guide download pdf (Page 7)

Description of the device

Features

The Showtec ImageSpot 300 is a promospot with high output and great effects.

• Die-cast and extruded aluminum finish

• Twin lens condenser, spherical reflector and external standard lens (1:2.4/100 mm)

• Two electrified guides carry a 24V supply and can accommodate a lens and housings for gobos and colors

• Different diameters gobos and filters are optional for static or motorized effects

• Micro switch cuts off electricity supply when cover is opened

• Thermal cut-out

• Lamp HTI 300

• 20000 Lumen

Overview

Fig. 1

Installation

Installing the Lamp

The Showtec ImageSpot 300 uses the HTI 300 (ordercode 80917) reflectorbulb as manufactured by all

popular manufacturers. Use only the appropriate lamp for your unit.

Note that, product versions that use other lamps, may be offered in the future. Check your product

specification label for information.

Always disconnect from electric mains power supply before changing lamps.

The lamp has to be replaced when it is damaged or deformed due to the heat.

Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the

device was not designed for.

Damages caused by non-observance are not subject to warranty.

Procedure :

1. Disconnect the fixture from power and allow the lamp to cool. Loosen the 2 screws and remove the top

cover.

2. Loosen the 2 thumb screws from the lamp socket.

3. Gently take the old lamp out. Read lamp instructions. This fixture is fitted with a metal halide lamp. Do not

touch the lamp bulb glass. Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the

glass with a clean, lint-free towel and rubbing alcohol.).

4. Replace the new lamp and refit the 2 thumb screws.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

SHOWTEC ImageSpot 300 User's Guide Page 7