SHOWTEC ORDERCODE 30645 User's Guide download pdf (Page 13)

Auto / Music /Manual Mode

Auto

1) Press the Mode button until the LED in front of Auto lights up green.

2) You can control the Speed and Fade Time by adjusting the Speed and Fade Time fader.

Music

1) Press the Mode button until the LED in front of Music lights up green.

2) You can control the Audio sensitivity by adjusting the Audio fader.

Fade Time is not available in Music Mode

Manual

1) Press the Mode button until the LED in front of Manual lights up green.

2) With Tap Sync you can manually go through the chase steps.

Fade Time is not available in Manual Mode

Strobe Mode

1) Press the Strobe button to enter Strobe Mode.

2) You can control the strobe speed with the Speed fader.

3) To exit the Strobe Mode, make sure that the speed fader is at 0.

Now press the strobe button to exit the Strobe Mode.

Strobe can not be recorded in a scene or chase

Maintenance

The Showtec LED Operator 4 requires almost no maintenance. However, you should keep the unit clean.

Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in

liquid. Do not use alcohol or solvents.

Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections

with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying

electric power.

Troubleshooting

Showtec LED Operator 4

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps.

1. Fixture does not respond to controller: Check the DMX-address of the fixture and the controller.

Make sure they match. Make sure the connections are correct.

2. Interference between chases; If the same channel is assigned to different running chases, the one

with the highest channel value will be put out.

3. If the device does not operate properly, unplug the device.

4. Check power from the wall, all cables, the settings, etc.

5. If all of the above appears to be O.K., plug the unit in again.

6. If nothing happens after 30 seconds, unplug the device.

7. Return the device to your Showtec dealer.

1 2 ... 8 9 10 11 12 13 14 15

No comments

SHOWTEC ORDERCODE 30645 User's Guide Page 13