SHOWTEC Spectral D4000 User's Guide download pdf (Page 19)

1) Enter UPLD to upload the custom programs from the current MASTER device to all SLAVE devices.

In order to activate the upload function the password must be entered.

Password: UP > DOWN > UP > DOWN. Then press ENTER to confirm your password.

When uploading the MASTER and SLAVE units will light up YELLOW.

If an error occurs when uploading the MASTER and/or SLAVE devices will light up RED.

When uploading one of the custom programs has been successful, the MASTER and SLAVE devices will

light up GREEN.

2) In order to reset the custom modes to its default values select REST.

3) Enter the ID Mode and select On in order to allow ID address function.

4) When you have selected RGBW to ON, RGB TO WHITE has been set.

This means RGB = 255, 255, 255. The color is displayed as you have calibrated the specific color in menu

CAL2  RGBW.

When it is set to NO, on RGB = 255,255,255, the RGB values are not adjusted and the output is most

powerful. The RGB’ s parameter can be adjusted in CAL2 .

5) Enter POW menu to choose NORM or HIGH power operation mode.

When the Spectral D4000 is in normal mode, the power consumption is about 90W. In high mode, it is

about 150W.

6) Enter DIM Mode to select a certain dimmer mode and dimmer speed.

When DIMMER is set to OFF, then RGBW and the MASTER DIMMER are linear.

Dim 1/2/3/4 are speed modes of the non linear dimmer. DIM1 is fastest, and DIM4 is slowest.

The DIM setting doesn not have any effect in STAG mode.

White Settings

• Enter CAL1 menu to select the white colors of a certain color temperature.

• There are 11 pre-programmed White colors that can be edited by using RED, GREEN, BLUE and WHITE.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

No comments

SHOWTEC Spectral D4000 User's Guide Page 19