SHOWTEC Phantom 575 Pro EB User's Guide download pdf (Page 10)

Backside

Fig. 2

3 4 5

3) IEC power connector + Fuse F3A 250V

4) DMX signal connector (IN) 3-pin

5) DMX signal connector (OUT) 3-pin

Installation

Remove all packing materials from the Phantom 75 LED Spot. Check that all foam and plastic padding is

removed. Connect all cables.

Do not supply power before the whole system is set up and connected properly.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Connect the device to the main power supply. The device can be music-controlled by its built-in

microphone.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

SHOWTEC Phantom 575 Pro EB User's Guide Page 10