SHOWTEC Scanmaster 1 User's Guide download pdf (Page 15)

FADE TIME

Fade Time / Assign Fade Time

1) With the power off, press the MODE and Tap/Display buttons at the same time.

2) Turn the power back on, tap the Tap/Display button to change between Fade Time and Assign Fade

Time, the LCD shows:

3) Press the MODE and Tap/Display buttons at the same time to store your setting into memory. If you do

not wish to save your setting, press the blackout key to exit this operation.

PLAYBACK

Running Scenes

There are three modes in which you can run scenes and chases. They are Manual mode, Auto mode and

Music mode.

Manual Mode

1) When the power is turned on, the unit automatically enters Manual mode.

2) Check and verify that both the Auto and Music LEDs are off.

3) Use the BANK Up/Down button to select the bank with the scenes you wish to run.

4) Press the SCENE button to display the scene you wish.

Auto Mode

This function allows you to run a bank of programmed scenes in sequence.

1) Press the Auto/Del button to enter Auto mode. The Auto LED will light, indicating the Auto mode is active.

2) Use the BANK Up/Down button to select a bank of scenes to run.

3) After selecting the bank of scenes to run, you can use the Speed slider and Fade Time slider to adjust the

speed of the scene progression.

4) You can use the Tap Sync/Display button to set the speed instead. The amount of time between the last

two taps will instruct the controller in the length of time between steps. This setting will stay in effect, until

the speed slider is moved.

5) Press the Auto/Display button to exit Auto mode.

Music Mode

1) Press the Music/Bank Copy button to activate Music mode.

2) Use the BANK Up/Down button to select a bank of scenes you wish to run. The scenes selected, will run

sequentially to the beat of the music, controlled by the built-in microphone.

3) Tap the Music/Bank Copy button again to exit music mode.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

SHOWTEC Scanmaster 1 User's Guide Page 15