SHOWTEC Scanmaster 1 User's Guide download pdf (Page 9)

Backside

Fig. 2

21) AUDIO LINE INPUT

0.1V~1Vp-p

22) MIDI IN

Used to receive MIDI data.

23) DMX polarity select

Used to select DMX polarity (2-,3+ / 2+,3-).

24) DMX OUT

This connector sends your DMX value to the DMX scanner or DMX pack

25) DMX IN

This connector accepts your DMX input signals.

26) Fog Machine Output

To send the signal to a fog machine.

27) DC INPUT

DC 9 ~15V, 500mA min.

28) POWER ON / OFF

Used to switch on / off the power.

Installation

Remove all packing materials from the Scanmaster 3. Check that all foam and plastic padding is removed.

Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

The Scanmaster 3 allows you to program 12 scanners with 16 DMX channels each; 30 banks of 8

programmable scenes, 6 chases of 240 scenes using 8 channel sliders, a joystick and other buttons. With

the ease of the joystick, you can easily and more accurately control the movement of a fixture. To further

dazzle the audience, this unit allows you to assign DMX channels. In addition 2 units can set up

communication, so that they send or receive a complete file dump.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

SHOWTEC Scanmaster 1 User's Guide Page 9