SHOWTEC ORDERCODE 30645 User's Guide download pdf (Page 8)

Installation

Installing the Lamp

The Showtec Multi Profile Spot uses a HPL-575 Lamp (ordercode 80812O / 80812G / 80815G), as

manufactured by all popular manufacturers. Use only the appropriate lamp for your unit.

Note that, product versions that use other lamps, may be offered in the future. Check your product

specification label for information.

Always disconnect from electric mains power supply before changing lamps.

The lamp has to be replaced when it is damaged or deformed due to the heat.

Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the

device was not designed for.

Damages caused by non-observance are not subject to warranty.

Procedure :

1. Disconnect the Multi Profile Spot before installing the lamp.

2. Loosen the knurled bolt on the back of the lamp housing and pull the housing out.

3. Holding it by the base, remove the lamp from its retention box. Do not touch the lamp bulb glass. Oil on

hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free towel

and rubbing alcohol.)

4. line up the lamp base with the hole of the retention box (Fig. 3).

5. Push down on the lamp base until the lamp seats firmly. Caution/ Improperly installed lamps cause

premature lamp failure and socket problems.

6. If your lamp is not same as Figure 3, and it is same as Figure 4, please remove the retention box. then

firmly insert the lamp into the socket by pushing the lamp base. (Not: Remain the retention box for the

future).

7. Reinstall the lamp housing by aligning the bolt hole and tightening the knurled bolts.

Fig. 3 Fig. 4

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

SHOWTEC ORDERCODE 30645 User's Guide Page 8