10
Chase
Select the CHASE (2) you want to program. Make sure that the “chase” you want to program, is actually
selected. By using the faders (4) you can set the preferred set up. When everything has been set to your
need, press the RECORD button (15) to confirm and all LEDs will flash for a moment. Repeat these steps,
until all steps are in the chase. Press the DEL button (13) to delete the current step, all LEDs will flash once.
Adjusting the speed of a chase
The speed of a CHASE (2) can be adjusted (during programming) by using the speedfader (25).
Hold down the RECORD button (15) for 5 seconds, and select an empty “chase”.
Select a FIXTURE (3), set the faders (4) and move the speedfader. On the left side of the display you can
see the length of every step of the chase (in seconds). All lengths from the steps will be stored in the
“chase”.
The speed can also be changed during a Live Mode “chase”’. Hold down the particular “chase” button of
which you want to change the speed manually and at the same time press the mix/sequence button (6). The
blinking speed of the LED (above the chase button) changes. If the LED blinks slowly, the pre-programmed
“speed” will be held. If the LED blinks fast, the “speed” and “fade” can be set by using the faders (4).
Erase a Chase or Scene
Hold down the RECORD button (15) for 5 seconds, and the green LED will illuminate.
The LCD now shows:
SELECT A SCENE OR CHASE! PAGE01
- Press the SCENE button you want to delete. Hold down the SCENE button and at the same time press the
DEL button (13). Then press the ESC button (16) to exit the menu. You will see that the LED, which was
previously on (next to the SCENE), now is off. This means the SCENE has been deleted.
- Press the button CHASE you want to delete. Hold down the CHASE button and at the same time press the
DEL button (13). Then press the ESC button (16) to exit the menu. Now the CHASE has been deleted.
Exit Record
Press the ESC button (16) when all steps have been entered, then press the button again to exit the menu.
Play Scene / Chase
The LEDs of the pre-programmed “scenes” illuminate green. The “scenes” of which the LEDs are off, are
not programmed. Press the button of a “scene” or “chase” you want, to activate it. Press the button again to
deactivate. The LEDs from the “chase” only blink after the chase has been activated/selected. Chases that
haven’t been programmed can’t be selected.
Page (5)
When the PAGE button (5) has been activated, you can view the pages of the moving light effects.
CH.PAGE button (19)
Press this button to switch between CH 1-8 and CH 9-16. LED “off ” means 1-8 channels available, while
LED “on “ means 9-16 channels available.
Tap sync (8)
With this function you can press the “chase” speed manually. The speed, with which you press the button, is
the speed of the “chase”. This option is often used, when the “chase” has to follow the rhythm of the music.
(26 pages)
(2 pages)
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals