SHOWTEC Light Desk Pro 136 User's Guide download pdf (Page 17)

PAN / TILT FADE ONLY

Enter the setting mode to choose item “3. P/T FADE ONLY”, and press the RECORD button (15) to enter

“PAN/TILT FADE ONLY” mode.

Further information will be shown on the LCD:

FIXTURE1: ONLY

OK ESC SEL ADJ

Select fixtures by the UP button, and press the DOWN button to select “FADE ONLY” or ”FADE ALL”.

Press RECORD (15) to confirm your operation, and ESC (16) to cancel or exit.

Display mode (100/255)

Enter the setting mode and choose item “4. DISPLAY MODE”, then press the RECORD button (15) to enter.

LCD will show you:

DISPLAY MODE : X X X

OK ESC CHANGE

Select mode 100 or mode 255 by UP/DOWN buttons. “100” is for value in percents (%), “255” is for values

in DMX steps.

Press “RECORD” to confirm your operation, use “ESC” to cancel or exit.

MIDI channel

Enter the setting mode and choose “5. MIDI CH.”, then press RECORD button (15) to enter the relevant

further operation. LCD will show you:

MIDI CH. <X X>

OK ESC CHANGE

Select relevant MIDI channels (1-16) by UP/DOWN buttons.

Press “RECORD” to confirm your operation, and use “ESC” to cancel or exit.

Notice for CF card

Do not pull out the CF card when being used.

Power must be assured “on”, when reading or storing to CF card.

Turn off the power when connect or disconnect CF card with the unit.

CF card (32MB) can be used only for Light Desk Pro 136; otherwise the data would probably be missing.

Outputting of DMX would be stopped during the reading or storing to CF card. And so does to “ASSIGN

CH.” mode.

CF card may become hot during use. Please observe due caution when removing memory cards from this

device.

Take good care of the CF card, and keep it in good conditions.

1 2 ... 12 13 14 15 16 17 18 19 20 21

No comments

SHOWTEC Light Desk Pro 136 User's Guide Page 17