SHOWTEC Zipp LED DMX User's Guide download pdf (Page 9)

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

After you connected the effect to the mains, the LED SCAN starts running. During the Reset, the motors are

trimmed and the device is ready for use afterwards.

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master

device.

On the rear panel of the LED SCAN you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In),

which can be used for connecting several devices.

Choose the device which is to control the effects. This device then works as master-device and controls all

other slave-devices, which are to be connected to the master-device via a balanced microphone lead.

Connect the DMX OUT-jack with the DMX IN-plug of the next device.

Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.

Please note: The function G-3- is only meant for service-purposes. Please do only use this function if you

want to set the unit shortly into standby mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

SHOWTEC Zipp LED DMX User's Guide Page 9