SHOWTEC DJ Switch 8 User's Guide download pdf (Page 11)

Multiple DJ LED Flowers (DMX control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. Use a 3-p XLR cable to connect the DJ LED Flower.

The pins:

1. Earth

2. Signal -

3. Signal +

3. Link the units as shown in (Fig. 4), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

4. Set DMX dip switches as follows (See Dip Switch setting page 10).

DJ LED Flower Address Value DMX Dip Switches "ON"

Unit 1 1

Unit 2 7

Unit 3 13

Unit 4 19

5. Supply electric power: Plug the end of the mains power cord into proper electric power supply sockets.

Do so for all units and the controller.

DMX-Set up

Fig. 4

Note : Link all DMX cables and set dip switches before connecting electric power

6. Do not supply power before the whole system is set up and connected properly.

Design your show according to your DMX controller functions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

SHOWTEC DJ Switch 8 User's Guide Page 11