SHOWTEC DimMaster User's Guide download pdf (Page 10)

Installation

Remove all packing materials from the DimMaster. Check that all foam and plastic padding is removed.

Screw the equipment onto the wall. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

When power is applied to your dimmer, a self-test is performed, as indicated by its LCD. The LCD reads "DMX

ABSENT/ DMX RECEIVED OK/ DMX SIGNAL ERROR" or "OVER TEMPERATURE".

After these initial test, a text message begins to scroll through the LCD. By default these messages are

"DIGITAL DIM PACK ......". You may change these text using menu item 71.

Menu System

Tap the UP/DOWN button to scroll through this menu system. There are total 9 main menus, the table below

shows every main menu and also gives you an explanation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

No comments

SHOWTEC DimMaster User's Guide Page 10