SHOWTEC DimMaster User's Guide download pdf (Page 20)

Additional Information

FAN COOLING

The unit's fan is controlled by built-in temperature sensor. When the temperature(NOW TEMPERATURE)

detected by the sensor is less than 40 Celsius, the fan will switch on discontinuously.

When the temperature exceeds 40 Celsius, the fan will switch on continuously.

OVER TEMPERATURE SOLVING

A. When the recorded maximum temperature exceeds 70 Celsius and the ambient temperature is below

70 Celsius, the LCD shows "OVER TEMPERATURE" and only 50% of output remains.

You may make RESET adjustment using menu 82 to resume normal output.

B. When the recorded maximum temperature exceeds 70 Celsius and the ambient temperature is also over

70 Celsius, the LCD shows "OVER TEMPERATURE" and only 50% of output remains.

You can not make any adjustments until over temperature is solved.

C. In normal use, whenever over temperature occurs, the LCD should show " OVER TEMPERATURE"

immediately and only 50% of output remains.

MASTER / SLAVE LINK UP

A. You can set up communications between several units using Master/Slave link up, the first unit serves as

the Master, and the others are Slaves. (See menu 6 UNIT SETUP.)

B. The Master unit transfers the DMX signal and Map input signal to the Slave unit using DMX cables,

the Slave transfers the DMX input signal only but not the Map input signal.

LOCK THE BUTTONS

After power on, the LCD shows general status and test messages. Press and hold down YES and NO buttons

simultaneously for three seconds, the LCD should show "L" in the down right corner indicating all the buttons

are locked. Press the two buttons for three seconds again, the "L" character disappears and the

buttons are unlocked.

In menu 311, you may also lock or unlock the buttons as described above.

In menu 311 or 41, if you don't make any adjustments within 10 minutes, the buttons should be locked

automatically, you may press and hold down YES and NO buttons for three seconds to unlock the buttons

and go on your setting. In other menus, if you don't make any adjustments within 10 minutes, the buttons

should be locked automatically, the LCD shows the status messages and you should restart your menu

adjustments.

1 2 ... 15 16 17 18 19 20 21 22 23

No comments

SHOWTEC DimMaster User's Guide Page 20