SHOWTEC Scanmaster 1 User's Guide download pdf (Page 16)

Running Chases

Manual Mode

1) When the power is turned on, the unit automatically enters manual mode.

2) Select the chase you wish to run by pressing the corresponding CHASE button. Pressing this button a

second time, this will unselect the chase.

Auto Mode

1) Press the Auto/Del button to activate Auto mode.

2) Select the desired Chase by pressing one of six CHASE buttons. Pressing this button a second time will

undo this selection.

3) Use the SPEED slider and FADE time slider to adjust the chase to your specifications.

Music Mode

1) Press the Music/Bank Copy button to activate Music mode.

2) Select the desired chase by pressing one of six Chase buttons, this will activate the chase and cause it to

respond to the rhythm of the music.

FILE TRANSFER

File Transfer allows the user to transfer all information stored in one Scanmaster 3 to a second Scanmaster

unit. You must connect the units using 3-pin XLR cables. The unit sending the information will have the

cable plugged into the DMX Out plug, and the receiving the information will have the cable running into the

DMX In location.

To Send A File Dump

1) With the power off, press and hold down the SCANNER 2 and 3 buttons and SCENE 1 button at the

same time.

2) Turn the unit back on, while pressing these three buttons, the LCD will read "TRANSMIT" indicating that

the unit is ready to send the files.

3) Press SCENE button 7 and 8 at the same time to send the file dump.

4) If an error occurs during the file dump, the LCD will show "ERROR".

Receive File Dump

1) With the power off, press and hold down the SCANNER 8, 9 and SCENE button 2 at a time.

2) Turn the unit back on, while pressing these three buttons, the LCD shows "RECEIVE", indicating this unit

is receiving the file dump.

3) When receiving is finished, the unit will automatically return to normal mode.

MIDI Channel Setting

1) Press and hold the MIDI/Rec button for three seconds. The LCD shows the MIDI channel of last time.

2) Use the BANK Up/Down button, to select the DMX channel 01 -16 you wish to assign to the MIDI

channel.

3) Press and hold the MIDI/Rec button to save your settings. The LEDs will flash three times, indicating that

the required operation has been performed.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

SHOWTEC Scanmaster 1 User's Guide Page 16