SHOWTEC Explorer 1200 User's Guide download pdf (Page 11)

Installation

Installing the Lamp

The Showtec Explorer 1200 uses the MSR 1200SA (ordercode 80950) bulb as manufactured by all popular

manufacturers. Use only the appropriate lamp for your unit.

Note that, product versions that use other lamps, may be offered in the future. Check your product

specification label for information.

Never run the device without lamp!

Always disconnect from electric mains power supply before changing lamps.

The lamp has to be replaced when it is damaged or deformed due to the heat.

Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the

device was not designed for.

Damages caused by non-observance are not subject to warranty.

Procedure :

1. Loosen the 2 screws ( A, B) on the backside of the lamp cover. See Backpanel Fig. 3

2. Gently pull out the lamp board.

3. Read lamp instructions. Do not touch the lamp bulb glass.

Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free

towel and rubbing alcohol.).

4. Insert the lamp pins into the small holes in the lamp socket. You can adjust the distance between the

lamp and the lens (screw X, Y, Z) on the back.

5. Put the backpanel back and fasten the screws snugly.

Fig. 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

No comments

SHOWTEC Explorer 1200 User's Guide Page 11