SHOWTEC Indigo 150 LED User's Guide download pdf (Page 26)

No Response to DMX

Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card

malfunction.

1. Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.

Try your DMX control again.

2. Determine whether the controller or light effect is at fault. Does the controller operate properly with

other DMX products ? If not, take the controller in for repair. If so, take the DMX cable and the light

effect to a qualified technician.

Problem

Probable cause(s)

Remedy

One or more

fixtures are

completely dead.

No power to the fixture

· Check that power is switched on

and cables are plugged in.

Primary fuse blown.

· Replace fuse.

Fixtures reset

correctly, but all

respond

erratically or not

at all to the

controller.

The controller is not connected.

· Connect controller.

3-pin XLR Out of the controller

does not match XLR Out of the first

fixture on the link (i.e. signal is

reversed).

· Install a phase reversing cable

between the controller and the first

fixture on the link.

Fixtures reset

correctly, but

some respond

erratically or not

at all to the

controller.

Poor data quality

· Check data quality. If much lower

than 100 percent, the problem may

be a bad data link connection, poor

quality or broken cables, missing

termination plug, or a defective

fixture disturbing the link.

Bad data link connection

· Inspect connections and cables.

Correct poor connections. Repair or

replace damaged cables.

Data link not terminated with 120

Ohm termination plug.

· Insert termination plug in output jack

of the last fixture on the link.

Incorrect addressing of the fixtures.

· Check address setting.

One of the fixtures is defective and

disturbs data transmission on the

link.

· Bypass one fixture at a time until

normal operation is regained: unplug

both connectors and connect them

directly together.

· Have the defective fixture serviced

by a qualified technician.

3-pin XLR Out on the fixtures does

not match (pins 2 and 3 reversed).

· Install a phase-reversing cable

between the fixtures or swap pin 2

and 3 in the fixture, that behaves

erratically.

Shutter closes

suddenly

The color wheel, gobo wheel, or a

gobo has lost its index position and

the fixture is resetting the effect.

· Contact a technician for servicing if

the problem persists.

No light

The power supply settings do not

match local AC voltage and

frequency.

· Disconnect fixture. Check settings

and correct if necessary.

LEDs damaged

· Disconnect fixture and return to your

dealer.

Lamp cuts out

intermittently.

Fixture is too hot.

· Allow fixture to cool.

· Clean fan.

· Make sure air vents at control panel

and front lens are not blocked.

· Turn up the air conditioning.

The power supply settings do not

match local AC voltage and

frequency.

· Disconnect fixture. Check settings

and correct if necessary.

1 2 ... 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

SHOWTEC Indigo 150 LED User's Guide Page 26

Comments to this Manuals

Related products and manuals for Floodlights SHOWTEC Indigo 150 LED