SHOWTEC Matrix 5x5 Blinder User's Guide download pdf (Page 21)

Control Panel Functions

For synchronous operation of multiple fixtures the fixtures must all be connected on a data-link.

Note: Disconnect the fixtures from the DMX controller before operating, otherwise data collisions can

occur and the fixtures will not work properly!

It’s necessary to insert the XLR termination plug (with 120 Ohm ) into the input of the first fixture and into

the output of the last fixture in the data-link, in order to ensure proper transmission on the data link.

DMX Addressing

With this menu you can set the DMX address.

1) Press Mode and then press the Up button, the display shows the actual DMX address.

2) The display is now blinking. You can choose 512 different DMX addresses.

Use the Up / Down buttons to select the required DMX address from 000 – 511.

3) Press and hold down the Mode button for 5 seconds to store your address.

Mode Menu (4CH, 9CH, 25CH and 29 CH)

With this menu you can set your desired operating mode.

1) Press Mode twice, the display shows the actual operating mode. The display is now blinking.

2) You can choose 4 different operating DMX modes: 4 CH Basic Mode

9 CH Zone Mode

25 CH Matrix Mode

29 CH Advanced Mode

3) Use the Up / Down buttons to select the required operating mode.

4) Press and hold down the Mode button for 5 seconds to store operating mode.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

No comments

SHOWTEC Matrix 5x5 Blinder User's Guide Page 21