SHOWTEC Phantom 250 Spot User's Guide download pdf (Page 11)

Control Modes

There are 4 modes: • Stand-alone (built-in programs)

• Sound-controlled

• Master/Slave

• DMX512 (13 Channels ADVANCED or 8 channel BASIC)

One Phantom (Built-in Programs)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the Phantom is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 15 for more information about the built-in programs.

One Phantom (Sound-control)

1.Plug the end of the electric mains power cord into a proper electric power supply socket.

2. Turn on the music. If the device is set to sound-control, then the Phantom will react to the beat of the

music. Please see page 15 for more information about the sound-control options.

Multiple Phantoms (Master/Slave control)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. Use a 3-p XLR cable to connect the Phantom.

The pins:

1. Earth

2. Signal -

3. Signal +

3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"

socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

You can use the same functions on the master device as described on page 15 (Built-in Programs,

or Music control). This means on the master device you can set your desired operation Mode

and all slave devices will react the same as the master device.

Multiple Phantoms (Master/Slave control)

Fig. 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

No comments

SHOWTEC Phantom 250 Spot User's Guide Page 11