2.8 Master control assignment
There are up to 16 master controls available in the Showdesigner 1024. Each of them can be assigned to
any channel.
Press Program to enter the programming mode.
Press Group 2 to select a master control.
Select one of the number buttons 1-16, as the number to store the master control
Move the channel faders you want to assign to the master control until the LED
indicators of the faders are lit.
Press the number button again to save and exit.
2.9 Run a master control
Press Group 2 to enter the programming mode.
Select the number button in which the master control is stored. If the LED indicator is lit,
Run the master control by moving the master fader.
Note:
The 16 master faders have number 17-32.
2.10 Jog wheel assignment
The pan/tilt channel of the fixtures can be assigned to the jog wheels on the controller for easy control.
Pan/ tilt channels have to be assigned for every fixture separately.
Press Program to enter programming mode.
Select <=/SETX or =>/SETY
Select the desired fixture.
Move the fader of the pan/tilt channel until the LED indicator is lit.
Press <=/SETX or =>/SETY again to save and exit
2.11 Using the jog wheels
The channel assigned to the jog wheel can be controlled by the jog wheel.
Press E/ XY, make sure the LED indicator is on.
Select the desired fixtures.
Control the fixture with the jog wheels.
Comments to this Manuals